A rapid positioning device for pole dance poles that considerably reduces the risk of the pole falling in case of sudden decrease of friction. Available in paintable stainless steel or iron.
Safety Plate diameter: 15cm or 11cm depending on the type of plate on your pole
The pressure pole is inserted between the petals of the Safety Plate, which is fixed to the ceiling by small holes or glue. The Safety Plate makes it easier and quicker to place the pole and prevents lateral sliding of the superior plate, considerably reducing the risk that the pole will fall in case of sudden decrease of friction.
The Safety Plate can be installed under the beam, the minimum width of the beam must be 11 cm.
Made of a carbon steel plate that is fixed to the ceiling by glue or small screws, it can be painted to be perfectly integrated in the room’s decor.
- bonding or fischer sx 5x25 expansion plug, sx-s countersunk screw
- Compatible with
- All poles from the OnlyOne series
- 300 gr
- 3 mm
- 15 cm
- in stainless steel or paintable iron
- Works with any surface
- Cement, wood, steel
- Recommended for use with
- TPS (Total Pole System) and Kit Pole&Silk
It might also interest you
Piece of pole to adapt your OnlyOne pole with GeckoGrip coating to new heights. Coating: Glossy white or glossy black GeckoGrip Diameters: 40 mm or 45 mmSteel thickness of 45mm pole: 3mm or 4mm...
The plate for square truss allows you to install pole dance poles under compatible square truss without any structural damage and in complete safety. The plates for square truss are compatible with...
To adapt your OnlyOne pole with UltraGrip to new heights. Coating: Matt light grey or black UltraGrip (rubberised) Diameters: 45 mm or 51 mm Maximum ceiling height for Poles: with a lower section...
Piece of pole to adapt your OnlyOne INOX pole to new heights.Coating: INOX - 100% STAINLESS STEELDiameter: 45 mm Maximum ceiling height for Poles:with a lower section of 200 cm in length: 420 cm...