3D Ceiling Head for OnlyOne poles
  • 3D Ceiling Head for OnlyOne poles
  • 3D Ceiling Head for OnlyOne poles
  • 3D Ceiling Head for OnlyOne poles
  • 3D Ceiling Head for OnlyOne poles
  • 3D Ceiling Head for OnlyOne poles
  • 3D Ceiling Head for OnlyOne poles
  • 3D Ceiling Head for OnlyOne poles
  • 3D Ceiling Head for OnlyOne poles

3D Ceiling Head for OnlyOne poles

€159.84 Tax excluded
SHIPPING TIME: 5 WORKING DAYS
3D head for pole:
 Calculate Shipping Cost
Shipping:
Free
to Italy via Ritiro in Negozio - Via Padre Albisetti 12, Terno d'Isola (BG)
Estimated delivery: No estimated delivery specified

Made with 3D technology, it allows the installation of OnlyOne poles even in environments with sloping ceilings or beams.

Maximum inclination of the ceiling or beam: 30 °.
Minimum beam width: 10 cm.

The 3D head consists of two pieces:
1) The head: has a diameter of 11 cm and is installed by screws M6 and raw plug (screws and raw plugs not included). The screws and raw plug are not supplied because they must be chosen according to the composition of your ceiling or beam.
2) The pivot: it is equipped with a sphere and must be inserted in the upper part of the OnlyOne pole.

The head remains  screwed to the ceiling, the pole is installed under pressure; make sure that the surfaces in contact withstand a pressure of approximately 350 kg.

To purchase the correct 3D head, indicate the coating and the diameter of your pole.

The Pole & Silk kit is NOT compatible with this accessory.

Must have accessories

Accessories

ThePole-Cleaner

ThePole-Cleaner

€9.75
Pole Tamer - Clean master

Pole Tamer - Clean master

€7.38
Polipole Shake and Grip - liquid grip

Polipole Shake and Grip - liquid grip

€12.21
Polipole Shake and Dry

Polipole Shake and Dry

€12.21

The 3D Ceiling Head allows you to install a OnlyOne pole even in the presence of a sloping ceiling or beam: the inclination must not exceed 30 ° and the beam must be at least 10 cm wide.

The 3D Ceiling Head is made of aeronautical aluminum with CNC treatment and consists of two pieces:

1) The head: has a diameter of 11 cm and is installed screws M6 and raw plug. The screws and dowels are not supplied because they must be chosen according to the composition of your ceiling or beam.

2) The pivot: it is equipped with a sphere and must be inserted in the upper part of the OnlyOne pole.

The pole with the pivot is installed by pressure inside the head, make sure that the contact surfaces support a pressure of about 350 kg.

If you change the installation room, the 3D head can also be used under straight ceilings parallel to the floor, but it must always be screwed on.

The 3D Ceiling head is not provided with a predisposition for the Pole & Silk kit.

20.1025.001

Data sheet

Mounting
Screw fastening with anchors of 6 mm or 8 mm
Compatible with
All poles from the OnlyOne series
Suitable to Pole&Silk kit
No

Comments

It might also interest you